Is it necessary to use micro-lubrication technology for deep hole machining?

Deep hole processing belongs to a closed and semi-closed processing mode, the working environment is complex, no medium is used at all, and the existing technology is difficult to achieve. In order to solve these problems, it is necessary to use micro-lubrication technology for deep hole processing.

It is mainly to solve the problems of difficult chip removal, difficult cooling, difficult lubrication and large amount of cutting fluid. It is suitable for deep hole machining and drilling of various single pipes. The micro-lubrication deep hole machining system has changed the traditional pouring deep hole machining into a new type of environmentally friendly semi-dry machining, realizing the quasi-dry cutting of deep hole machining, and has made breakthrough progress in solving the problems of environmental pollution and energy consumption.

The micro-lubrication deep hole processing system combines the characteristics of deep hole processing and combines the advantages of a variety of modern green cooling and lubrication methods. It uses oil film with water droplets as cooling and lubricating medium, and is constructed by using a new negative pressure chipping device and a composite spray device. .